如何提高辐射供热系统的热工和水力性能

Problem description

Thermal and hydraulic results improvement by adjusting structural and operating parameters of a radiant system heater.
更多信息，见： Design of radiant heating floor and wall installation

Arrangement and size of radiant heaters - larger surface area of a 地面供热/供冷区 enables lowering supply temperature.

1. Size of 地面供热/供冷区

更多信息，见： Heating/cooling_zone
Maximum attainable supply temperature when heat pump is the source.
Maximum loop length - has effect on flow resistance and manifold size, and thereby also on operating and capital costs.

2.最大长度
Perimissible pipe spacing - has effect on mean surface temperature of radiant heater.

3. Pipe spacing
Insulation thickness under radiant heater - has effect on 辐射供热的热损失（向建筑之外）.

4. Insulation layer
Selection of proper 装饰层 in rooms - has effect on radiant heater efficiency and on uniform temperature distribution on heater surface.

5.装饰层

更多信息，见： Changing structural parameters

Supply temperature, if a system with adjustable temperature is used (e.g. gas-fired water heater with a mixer or a mixing pump set)
6. Supply temperature

更多信息，见： Modifying system parameters to adapt attained output to required output
Maximum flow rate in floor heating loops - possible by adjusting Δθ 最小内区, Δθ _{最大内区}, Δθ 最小外区 and Δθ _{最大外区} or by specifying 供回水温差.
7. Parameters that have effect on maximum flow rate in floor heating loops

更多信息，见： Changing operating parameters