墙体几何尺寸修正
跳转到导航
跳转到搜索
| 产品 | InstalSystem 5 |
| 文章类型 | FUNCTIONS AND TOOLS |
| 版本的最新内容 | 2021-11-26 |
Description
When creating a building structure (e.g. drawing rooms or walls) with the use of raster underlays the AUTO mode cannot be used. As a result of drawing inaccuracies, minute offsets are created between structural elements (e.g. walls) located on successive storeys. These may lead to improper interpretation of the building structure. In order to avoid difficult and time-consuming manual corrections to the structural model, a tool has been made available which automatically corrects the wall geometry. By using the 墙体几何尺寸修正 function such artifacts can be eliminated and proper building structure can be obtained.
The 墙体几何尺寸修正 tool can be used for the following purposes:
- 修改墙的连接 - among other things to rectify wall connections if these were not made correctly with the 自动生成墙、楼板和屋顶 function
- 修改墙的厚度 - to standardize wall thicknesses to specified thickness variants
- 修改墙的角度 - to fix the angles between connected walls
- 修改楼层间的位置 - to align the positions of walls located one above the other on successive storeys
Examples of use
The 墙体几何尺寸修正 tool has four options:
- 修改墙的连接
- 修改墙的厚度 - enables specifying/removing a permissible wall thickness. The 修改墙的厚度 tool standardizes the 厚度 of a 墙 to a defined value across the entire project.
- 修改墙的角度 - specifies the value of angle correction of a 墙. The 修改墙的角度 function modifies the value to a grid value, which by default is set to 3. The value is complemented to 90, 93, 96 and so on and adjusted accordingly. The angle shift does not depend on the position of the wall hotpoint.
- 修改楼层间的位置 requires specifying the tolerance (in cm) of the mutual vertical misalignment of 墙 type components. The storey with respect to which the alignment correction is to be made must also be indicated. ATTENTION! This function corrects the position of walls only, corrections in the area of horizontal slab partitions, if required, must be made manually.