环路给水系统的设计

产品	InstalSystem 5
文章类型	ZASTOSOWANIE PROJEKTOWE
版本的最新内容	GOLD Rev. 15.3

Scope of lesson

This lesson shows how to create a sanitary system loop installation. The latter is located in a single-family two-storey building with basement.

Modules and program configuration

• InstalSystem 5 software package with the following modules:
  • 给水系统
  • Tap water extensions
• Recommended: sanitary system pipe catalogues containing direct U-shaped tap water connection, which guarantees lack of no-flow zones within the system

在INSTALSYSTEM中的项目案例

项目文件 如何计算下载的文件?	Single-family building water installation initial state, isproj Water ring installation in a single-family building , isproj
设计时使用	InstalSystem 5 Rev. 17.0
所需模块	InstalSystem basis Tap water systems Tap water extensions
项目范围	Instalacje wodociągowe
所用的产品目录	Steel pipes, medium, DIN 2440 PEX (pipes and fittings) acc. to EN ISO 15875 Brass and steel pipe couplings and fittings Standard water taps and whiteware Miscellaneous fittings of any make standard insulation catalogue Neutral valves catalogue - typical construction
建筑类型	residential building with basement three-storey
建筑结构	Underlay - all plans, dwg
图纸范围	Plan views
设计者	100px www.instalsoft.com
法律免责声明	Copying of entire project and of its fragments allowed
计算结果	Tap water installation ring full printout, pdf Tap water installation ring bill components, pdf
设计图纸	All storeys, dwg Basement, pdf Groundfloor, pdf Attic, pdf

Initial state

The initial state file is located in the Project table, and it contains the building graphic structure and radiant sanitary system, which needs to be completed with a loop installation on the storey.
更多信息，见： Design of water supply system installation

Steps to perform

Turning on the program and project general data configuration

1. Turn the program on.
2. Load the project file - Single-family building water installation initial state, isproj.

Installation edition

1. Select storey No. 1.
2. Draw hot and cold water pipe feeds, so that a loop installation is created in room 1.5.

   

   1.Creating a loop installation.

   
   
3. With your mouse, select the area with terminal units and choose 自动用活水三通连接件连接末端用水点.
   
   
   
4. If needed, modify pipe feed ordinates to evade doors. To do so, insert additional division points for the pipe feed passing through the door opening.
   it is necessary to impose a correct ordinate. The correction of imposed values should be verified in the 3D视图 window.
   

   

   2. Omitting the door opening

   
   
   
   
5. Verify if the circulation circuit has been closed properly on the storey.
   

   

   3. Closing the circulation circuit on the first storey

   
   

Verification of the correctness of installation structure

1. Verify correctness of the installation structure using the 检查连接 function (shortcut: Shift + F2).
2. Verify correctness of the installation structure and find collisions using 3D视图.
   更多信息，见： Verification of the correctness of installation structure
   

Calculations and diagnostics

1. Perform 给水系统计算 by clicking on located in the 计算 section of the Main tools toolbar.
2. Verify calculation results.

更多信息，见： Calculations and diagnostics