如何删除诊断出的问题："不可能自动布置引线管 - 改变引线管路径或供热/供冷区参数或手动布置引线管"

Problem description

Problems associated with automatic generation of pipe feeds using the 引线管路径 tool are diagnosed by means of the following message:

• 自动布置引线管不可能。改变引线管路径，或供热/供冷区参数，或手动布置引线管 .

The message informs that pipe feeds could not be generated automatically by means of the 引线管路径 tool, due to the following reasons:

• specified or automatically sized arrangement spacings are too large,
• manner of component crossing 引线管路径 is inappropriate (for the algorithm of automatic pipe feed arrangement),
• number of component crossings 引线管路径 is too large,
• 引线管路径 components are located too close to each other,
• width of the strip within which 引线管路径 generates pipe feeds is too small or too large (reaches beyond the borders of the heating zone).

Solution

• Specify smaller pipe feed arrangement spacing.

• Change manner of 引线管路径 component arrangement.

• Increase width of 引线管路径 component arrangement area.

• Draw pipe feeds manually.

Depending on design circumstances, or when pipe feeds cannot be generated automatically, the tool for manual arrangement of pipe feeds can be used.
更多信息，见： Manual pipe feeds editing.

How to eliminate problems with the diagnostic message: "Automatic arrangement of pipe feeds not possible - change pipe feeds route or H/C Zone parameters or arrange pipe feeds manually"