如何删除: "在循环回路外的热水管网中水量太多"：修订间差异
跳转到导航
跳转到搜索
（建立内容为“<!--Case 258768--> <IS_HELP id="HS122"/> {{Article table |commercial_product1=InstalSystem 5 |p2 = |p3 = |p4 = |ca…”的新页面） |
无编辑摘要 |
||
| 第7行： | 第7行： | ||
|p4 = | |p4 = | ||
|category1 =InstalSystem 5#Tips&Tricks | |category1 =InstalSystem 5#Tips&Tricks | ||
|category_name1 = | |category_name1 =提示和技巧 | ||
|c2 = | |c2 = | ||
|category_name2 = | |category_name2 = | ||
| 第18行： | 第18行： | ||
}} | }} | ||
== | ==问题说明== | ||
Problems with too high installation capacity not included in circulation are diagnosed by the program with a diagnostic message: <br/> '''''<IS_TS id=strerrDzialkaPrzekroczeniePojemnosciInstalacjiNieObjetejCyrkulacja/>'''''. | Problems with too high installation capacity not included in circulation are diagnosed by the program with a diagnostic message: <br/> '''''<IS_TS id=strerrDzialkaPrzekroczeniePojemnosciInstalacjiNieObjetejCyrkulacja/>'''''. | ||
* The problem may occur when the part of hot water installation not included in circulation has capacity higher than declared in ''<IS_TS id=norma_obliczeniowa/>''. | * The problem may occur when the part of hot water installation not included in circulation has capacity higher than declared in ''<IS_TS id=norma_obliczeniowa/>''. | ||
2022年8月15日 (一) 12:54的版本
| 产品 | InstalSystem 5 |
| 文章类型 | 提示和技巧 |
| 版本的最新内容 | 2022-03-18 |
问题说明
Problems with too high installation capacity not included in circulation are diagnosed by the program with a diagnostic message:
在循环回路外的热水管网中水量太多 (%s).
- The problem may occur when the part of hot water installation not included in circulation has capacity higher than declared in 计算标准.
- When the selection of the ring part is selected in on the 计算标准, this diagnostic can also include the ring parts. It is impossible to connect the circulation to the ring.
Solution
To eliminate the message, the hot water source must have a circulation input.
- If a circulation installation already exists in the project, it should be extended to the farthest possible part of the installation (outside the ring).
1. Add a circulation pipe-run. - If a 户用换热机组 is used, select a model with the circulation input option (declare the use of a circulation set in the data table) and draw the circulation installation on the residential side.
2. Select the type of Flat station. - The value of the water capacity above which the message is generated is set in the field 允许的循环不到的部件中的水容量 on scope 计算标准 in the 一般参数 window.
3. Increase the values in 允许的循环不到的部件中的水容量
